.45 Conceal Carry Comp .578-28 Anodize BLK for FN, XDM45 & HK 45, clamp on

Description: YOU NEED A 37/64-28 THREADED BARREL TO USE THIS ITEM. DO NOT BUY THIS IF YOU DO NOT HAVE ONE. This is a high quality, aluminum muzzle brake compensator. It is made in the USA (Minnesota actually). Features include: .45 caliber Holsters Easy! Designed for concealed carry threaded for 37/64-28 (0.578-28) right handed threads (most common .45 threads) Loosen and tighten with 2 screws for easy on/easy off COUNTER-BORED: this feature on the slide facing side lets the brake get closer to the slide to make the gap smaller! (see picture of the side view) width is sized to match the FN45 (0.97" wide - measure yours to see if it will match), holsters easy - also works great with Glock 21 width slides flush with the top of the glock slide distance (or gap) from the front of the slide depends on your particular barrel but is reduced by up to 3/16" because of the Counter-bore. add roughly 0.79" to the length of the barrel (however far out yours sticks) Made of 6061 Aluminum Anodized black, hard coat type III held on with #6-32 x 1/2" socket head cap screws tighten set screws to 10-12 inch pounds This reduces felt recoil for carry, competition, or duty. Works better with higher grain/higher power loads (they have more gas to push back against the brake with). In some cases, very light gamer loads will not cycle the action unless springs are changed out. Narrow ports to reduce danger in deep retention from blast. Set screws are tightened with a 7/64" allen wrench. On screws this small about 10 inch pounds is all the tighter you want to get them.

Price: 38 USD

Location: Saint Paul, Minnesota

End Time: 2024-04-04T00:28:06.000Z

Shipping Cost: 0 USD