Can Am Maverick 1000 XMR XRS XXC Max Aluminum Intake Air Box CFM Performance

Description: All CFM Performance products are proudly Made In USA.Made from the highest quality materials including 0.083" 5052 series aluminum and stainless steel hardware.Comes with everything you need. No extra items to buy. No modifications are required. Install in about 60 minutes with basic hand tools. The stock air box uses a restrictive flat paper filter. It is too small and loads up with dirt too easily. This air box uses a 4" I.D. filter that is clamped to a heavy duty aluminum ring. It has 2 times more dirt holding capacity than the stock filter and there is no chance of it coming loose or allowing dirt to pass.Better throttle response and more power across the entire RPM range. This air box comes with 2 different lids. One lid will seal the top of the air box completely, just like your stock air box, so all air will come through the stock snorkel. With the full lid you will see a 2 horsepower increase. The second lid has an opening on both sides for increased air flow and a 4 horsepower increase. The third option is to run with no lid at all for a 6 horsepower increase. No fuel management unit is required with either lid in place. If you remove the lid, you will need a fuel management unit to see a 6 horsepower increase.This air box comes with an aluminum ring welded to the front and a 2 3/4" ID silicone hose eliminating the need to use the stock throttle body to air box tube. The stock throttle body to air box tube has a smaller 2 5/8" ID and requires that you seal it to the box with a silicone adhesive. Unlike your stock air box, this air box can easily be installed or removed in a few minutes without the hassle of removing or loosening the front fenders.The only aftermarket air box that allows you to use your stock snorkel, drain boot and crank case vent.This air box does not come with a crank case vent filter. Uses UNI filter UP-104 or K&N 62-1340 crank case vent filter.Does not come with an intake filter. Uses UNI filter NU-4102ST or K&N filter part number HA-4250. Will fit the following models:2013:Maverick 1000Maverick 1000 XRS 2014:Maverick 1000Maverick 1000 XMRMaverick 1000 XRS Maverick 1000 XXCMaverick Max 1000Maverick Max 1000 XRS 2015:Maverick 1000Maverick 1000 XMRMaverick 1000 XRSMaverick 1000 XXCMaverick Max 1000Maverick Max 1000 XRS 2016:Maverick XCMaverick XC DPSMaverick DPSMaverick Max DPSMaverick XMRMaverick Max XMR 2017:Maverick XCMaverick XC DPSMaverick X XCMaverick DPSMaverick Max DPSMaverick XMRMaverick Max XMR 2018:Maverick XCMaverick XC DPSMaverick X XCMaverick DPSMaverick Max DPSMaverick XMRMaverick Max XMR Please Read:We build these as we get paid for them. This allows us to sell the highest quality products at the lowest possible price. 99% of all items are delivered in the estimated time shown on eBay before you purchased. It is rare, but occasionally there can be a delay. Be patient, we always work hard to make sure you get what you paid for in a reasonable amount of time. Most customers agree, the high quality and low price is worth the wait.

Price: 309.95 USD

Location: Mayville, Michigan

End Time: 2024-07-21T23:10:48.000Z

Shipping Cost: N/A USD