XADO Revitalizant EX120 for cylinder-piston group

Description: Autumn saleI will ship to any country except Russia and Belarus. Revitalizant EX120 for cylinder-piston group Reinforced revitalizer. It is intended for restorative repair and the subsequent protection against operation of the cylinder-piston group of the engine without its dismantling. Forms a metal-ceramic coating on the surfaces of parts of the cylinder-piston group. As a result, the geometry of the cylinders is restored, their inner diameter is reduced, and the ellipse disappears. - Increases compression - Removes dents and scratches up to 0.1 mm - Protects cylinders from operation at cold start - Reduces noise and vibration - Increases engine power - Reduces fuel consumption - Reduces the content of CO and NS in the exhaust gases - Gives the chance of selective repair (processing of one or several cylinders) Application Processing of the cylinder of the internal combustion engine: - Warm up the engine (the engine should be warm but not hot) - Unscrew the spark plug from the cylinder, disconnect the central wire of the sensor of the distributor of ignition and the switch * Make the contents of 1 tube into the cylinder - Provide 15-20 strokes of the piston (scroll the suspended drive wheel, towing, etc.) - Twist the candle and scroll 3-4 times with the starter for 3-4 s at intervals of 15-20 s - Connect the central wire, the switch and, having started the engine, to provide its work at idling within 15 min. - Further operation - in normal mode * Apply the gel from the tube should be so that the composition falls on the walls of the cylinder, not on the piston. To do this, you can use a medical syringe with a coated tube, pre-dissolving the contents of the tube in 5-10 ml of motor oil. To avoid water hammer, the total volume of the liquid should not exceed 20 ml. Notes The treatment of the cylinder of a diesel engine is carried out similarly to the treatment of the cylinder of a gasoline internal combustion engine by applying a revitalizing gel through the hole of the injector or glow plug. 1 tube - 1 cylinder. If the cylinder diameter is more than 120 mm, the dosage should be doubled. Packaging tube in a blister of 9 ml, article XA 10338

Price: 15.25 USD

Location: Sumy

End Time: 2024-01-04T13:17:49.000Z

Shipping Cost: 10 USD